No results were found for the filter!
SOLAR-RIPP ® Manifold End With Thread Cap To drain and bleed the system. The end has already been fixed firmly in production; Not available separately. NEW: Screw now made of corrosion-resistant steel! Flat gasket 9mm thick. 12mm hexagon socket.
For prices, please sign in.
SOLAR-RIPP ® 180 degree connection special V1 Permanently attached to the distributor / collector at the factory. This component protrudes about 15cm from the solar surface on the side and top, material end fiber-reinforced, conical, with corrugation on the outside, suitable for a...
For prices, please sign in.
SOLAR-RIPP ® 180 degree connection special V2 Permanently attached to the distributor / collector at the factory. This component protrudes about 10cm laterally and about 15cm at the top from the solar surface, material end fiber-reinforced, conical, with corrugation on the outside,...
For prices, please sign in.
SOLAR-RIPP ® Air Separator 50 NEW product available in 2013: The newly designed SOLAR-RIPP ® air separator collects oxygen that is outgassed during operation as well as residual air that remains in the solar energy system after startup, especially in the upper inside...
For prices, please sign in.
SOLAR-RIPP ® Manifold End With Thread Cap,... To drain and bleed the system incl. flat gasket 9mm thick. and threaded plug with 12mm hexagon socket.
For prices, please sign in.
SOLAR-RIPP ® 0.75” MT Screw For Manifold End... Fits the SOLAR-RIPP ® SRGK, NEW, now finally made of rust-proof steel with 12mm hexagon socket and 3/4 "male thread.
For prices, please sign in.
SOLAR-RIPP ® 0.75” Flat Gasket 9mm Black, EPDM70°, OD=23,5mm, ID=10mm, T=7.5 - 9mm.
For prices, please sign in.
End Cap (For Manual Hand Valve) Made of black plastic, please use without flat gasket, with 3/4 "female thread.
For prices, please sign in.
Viewed